Installation Procedure
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Install the manual shaft detent (with shift position switch) lever assembly (4).
- Install the manual shaft (2).
- Install the manual shaft detent lever hub pin (1).
Specification
Install the manual shaft detent lever hub pin to height of 7.9 mm (0.38 in) (b).
- Install the NEW manual shift shaft pin (5) using DT-41229
pin installer. Use a NEW pin to ensure proper engagement with the case.
Specification
Inspect pin installed height is within 7.2-8.2 mm (0.28-0.32 in) (a).
- Install the control valve body. Refer to Control Valve Body Replacement .
- Install the automatic transmission range selector lever. Refer to Automatic Transmission Range Selector Lever Replacement .
- Install the engine coolant fan shroud. Refer to Engine Coolant Fan Shroud Replacement (2H0)Engine Coolant Fan Shroud Replacement (LUJ, LUV) .
- Perform the transmission adaptive values learn procedure. Refer to Transmission Adaptive Values Learn .
NOTE:
Connect the actuator rod (3) to the detent lever assembly.
CAUTION:
Use J 41229 to install the manual shaft pin at the correct height in order to properly secure the manual shaft. If you install the pin too deep, the case bore may crack.