Driver or Passenger Seat Cushion Outer Finish Panel Replacement (Manual)

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Driver Or Passenger Seat Cushion Outer Finish Panel (Manual)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the driver or passenger seat recliner handle. Refer to Front Seat Back Recliner Handle Replacement Remove the front seat vertical adjuster, if equipped. Refer to Front Seat Vertical Adjuster Replacement
1	Driver or Passenger Seat Cushion Outer Finish Panel Front Fastener CAUTION: Refer to Fastener Caution . Tighten 2.8 N.m (25 lb in)
2	Driver or Passenger Seat Cushion Outer Finish Panel Side Fasteners (Qty: 2) Tighten 2.8 N.m (25 lb in)
3	Driver or Passenger Seat Cushion Outer Finish Panel Procedure Make sure the seat is in the full up position. Gently pull outboard on the front half of the finish cover to disengage the panel rib from the seat frame. Firmly grasp the upper area of the finish cover that folds over the seat cushion frame, this area needs to be flexed outward while sliding the finish cover upward. If replacing the cover, transfer components as necessary.