LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System >> Repair Instructions >> Engine Coolant Thermostat Housing Replacement (1.4L LUV) >> Installation Procedure

Installation Procedure

  1. Clean the sealing surfaces.
  2. Install the engine coolant thermostat housing (5) along with a NEW seal ring (1).
    Fig 1: Identifying Engine Coolant Thermostat Housing And Engine Oil Cooler Outlet Hose
    GM2192302Courtesy of GENERAL MOTORS COMPANY
  3. Install the 3 engine coolant thermostat housing bolts (4) and tighten to 8 N.m (71 lb in).
    CAUTION: Refer to Fastener Caution .
  4. Install the engine oil cooler outlet hose (3) to the engine coolant thermostat housing.
  5. Install the engine oil cooler outlet hose clamp (2).
  6. Connect the engine coolant temperature sensor wiring harness connector.
  7. Install the radiator outlet hose to the engine coolant thermostat housing. Refer to Radiator Outlet Hose Replacement (1.4L LUV) .
  8. Connect the positive crankcase ventilation pipe to the turbocharger. Refer to Positive Crankcase Ventilation Hose/Pipe/Tube Replacement .
  9. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  10. Fill the cooling system. Refer to Cooling System Draining and Filling (GE-47716 Fill)  and Cooling System Draining and Filling (Static Fill) .
scientia non olet · About LEMON Manuals