LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Mechanical - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Oil Pan Removal (LS3, L99, or LSA)

Oil Pan Removal (LS3, L99, or LSA)

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Left Closeout Cover & Bolt
    GM178477Courtesy of GENERAL MOTORS COMPANY
    NOTE:
    • The original oil pan gasket is retained and aligned to the oil pan by rivets. When installing a new gasket, it is not necessary to install new oil pan gasket rivets.
    • DO NOT use the oil pan gasket again. When installing the oil pan, install a NEW oil pan gasket.
  1. Remove the left close out cover and bolt.
    2. Fig 2: View Of Right Closeout Cover & Bolt
    GM178480Courtesy of GENERAL MOTORS COMPANY
  2. Remove the right closeout cover and bolt.
    3. Fig 3: Engine Oil Pan & Bolts
    GM1565286Courtesy of GENERAL MOTORS COMPANY
  3. Remove the oil pan bolts (439 and 453).
  4. Remove the oil pan (400).
    5. Fig 4: Drilling Out Oil Pan Gasket Retaining Rivets
    GM1272840Courtesy of GENERAL MOTORS COMPANY
    NOTE:
    • DO NOT allow foreign material to enter the oil passages of the oil pan. Cap or cover the openings, as required.
    • Use care not to gouge, score, or damage the oil pan sealing surface.
  5. Drill (2) out the oil pan gasket retaining rivets (1), if required.
  6. Remove the gasket (426) from the pan.
  7. Discard the gasket (426) and rivets.
  8. Remove the oil level sensor, baffle and other internal components, as required. Refer to Oil Pan Cleaning and Inspection (LSA) Oil Pan Cleaning and Inspection (LS3 or L99) .
scientia non olet · About LEMON Manuals