Removal Procedure
- Disable the SIR System. Refer to SIR Disabling and Enabling .
- Remove the driver or passenger seat. Refer to Driver or Passenger Seat Removal and Installation .
- Remove the driver or passenger seat outer recliner finish cover. Refer to Driver or Passenger Seat Outer Recliner Finish Cover Replacement (Power) , Driver or Passenger Seat Outer Recliner Finish Cover Replacement (Manual) .
- Remove the driver or passenger seat inner recliner finish cover. Refer to Driver or Passenger Seat Inner Recliner Finish Cover Replacement .
- Remove the driver or passenger seat head restraint. Refer to Driver or Passenger Seat Head Restraint Replacement .
- Remove the cover by unclipping the two lower retainers and then slide the cover down.
- Unhinge the cushion strap (1) from the seat frame.
- Release the front seat back cushion from the backrest left side (1) and right side (2).
- Remove hog rings (3) to release the front seat back cushion from backrest.
- Release both fasteners (1, 2) from the seat side inflatable restraint module (3).
- Disconnect the wiring harness connector (2) from the seat side inflatable restraint module (1).
- Remove the front seat back cushion with the cushion pad (1) from the backrest frame (2).
- Remove the seat side inflatable restraint module (1) out of the textile (2) bag.
- Remove the hog rings from the seat cushion back (1), pull the cushion back cover from the cushion back pad (2).
WARNING:
Refer to SIR Warning .