LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Sonic RS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.8L (LUW, LWE)) >> Repair Instructions - On Vehicle >> Crankshaft Rear Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Crankshaft Rear Oil Seal And Installer
    GM2190821Courtesy of GENERAL MOTORS COMPANY
  1. Install the crankshaft rear oil seal (1) with EN-235-6  installer (2) contained in EN-235-D  kit.
    2. Fig 2: Installer Tool
    GM2190822Courtesy of GENERAL MOTORS COMPANY
  2. Use EN-658-1  installer (1) to strike the crankshaft rear oil seal.
  3. If equipped with a manual transmission install the flywheel. Refer to Engine Flywheel Replacement .
  4. If equipped with a automatic transmission, install the automatic transmission flex plate. Refer to Automatic Transmission Flex Plate Replacement .
scientia non olet · About LEMON Manuals