Engine Mount Replacement - Right Side

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Engine Mount - Right Side

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (LF1) or Air Cleaner Assembly Replacement (LAU) . Install engine support fixture. Refer to Engine Support Fixture . If equipped with LAU, reposition the power steering reservoir outlet hose. Refer to Power Steering Fluid Reservoir Outlet Hose Replacement (LAU) or Power Steering Fluid Reservoir Outlet Hose Replacement (LF1) . If equipped with LAU, remove the radiator inlet hose. Refer to Radiator Inlet Hose Replacement (LF1) or Radiator Inlet Hose Replacement (LAU) . Prior to removing the mount, mark the mount location using spray paint or a marker for correct positioning during installation. If all powertrain mounts are replaced, perform "Powertrain Mount Balancing". Refer to the appropriate engine information.
1	Engine Mount Fastener CAUTION: Refer to Fastener Caution . Tip: Perform the "Powertrain Mount Balancing-lower". Refer to the appropriate engine information. Tighten: 62 N.m (46 lb ft)
2	Engine Mount Fastener (Qty: 3) Tighten: 62 N.m (46 lb ft)
3	Engine Mount Fastener (Qty: 2) Tighten: 100 N.m (73 lb ft)
4	Engine Mount Procedure: Transfer components as necessary.