LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Corvette Z06 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission - 6L80 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Floor Shift Control Boot Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the console. Refer to Console Replacement .
  2. Remove the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
  3. Remove the floor shift control knob. Refer to Transmission Control Lever Knob Replacement .
  4. Remove the floor shift control from the vehicle to allow for boot replacement without possible damage to the boot retaining tabs. Refer to Transmission Control Replacement .
    5. Fig 1: Bulb To Lamp Socket
    GM190951Courtesy of GENERAL MOTORS COMPANY
  5. Remove the floor shift control boot from the floor shift control.
    1. Carefully squeeze the front and side tabs or the rear and side tabs at the same time in order to release them.
    2. Carefully squeeze the remaining tab in order to release it.
    3. Release the snap lock retainer on the LH side of the boot.
    4. Move the boot to the left and release the shift indicator guide pin from the shift control lever.
    5. Disconnect the indicator lamp socket from the boot.
    6. Remove the boot from the shift control.
scientia non olet · About LEMON Manuals