Inflatable Restraint Passenger Presence System Replacement - Front (Yukon and Tahoe Hybrids NOT Denali)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inflatable Restraint Passenger Presence System - Front (with HP2)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
WARNING: Refer to SIR Warning . WARNING: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly. Preliminary Procedure Remove the front seat. Refer to Front Seat Replacement - Bucket (without HP2) , Front Seat Replacement - Bucket (with HP2) . Remove the seat cushion cover and pad. Refer to Seat Cushion Trim Cover and Pad Replacement (without HP2) , Seat Cushion Trim Cover and Pad Replacement (with HP2) .
1	Inflatable Restraint Front Passenger Presence Sensor Retainer (Qty: 2)
2	Inflatable Restraint Front Passenger Presence System Procedure Lay the seat on its side. Unhook the connector from retainer on seat frame and push up through seat pan. Disconnect and remove the sensor.
3	Inflatable Restraint Front Passenger Presence Module Rivets (Qty: 2) Procedure Drill out the rivets to remove and install using new rivets.
4	Inflatable Restraint Front Passenger Presence Module Procedure The inflatable restraint passenger presence module must be replaced as a kit that also includes the sensor assembly. Re-zero the Tahoe Hybrid and Yukon Hybrid (not Denali) vehicles ONLY. All other vehicles no re-zero is needed. Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Control Module References .