Front Seat Replacement - Bucket (without HP2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Seat -- Bucket

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the front seat adjuster covers. Refer to Front Seat Adjuster Track Finish Cover Replacement . Disconnect the seat belt from the seat. Refer to Seat Belt Retractor Pretensioner Replacement - Front .
1	Front Seat Assembly Nut (Qty: 2) CAUTION: Refer to Fastener Caution . TIP: Adjust the seat rearward to access to the nuts. Tighten 55 N.m (41 lb ft)
2	Front Seat Assembly Bolt (Qty: 2) TIP: Adjust the seat forward to access the bolts. Tighten 90 N.m (66 lb ft)
3	Front Seat Assembly Disconnect the electrical connector. If removing and installing seat the center seat or floor console do not need to be removed.