LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Hinge Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Hood Hinge To Hood Bolt
    GM867790Courtesy of GENERAL MOTORS CORP.
  1. Position the hood hinge to the alignment marks on the vehicle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the hood hinge to body bolts and tighten to 10 N.m (89 lb in).
  3. Install the front fender. Refer to Front Fender Replacement .
  4. Remove the hood to air inlet grille panel support.
  5. Slowly lower the hood.
  6. Inspect the hood alignment. Align the hood if necessary. Refer to Hood Adjustment .
  7. Tighten the hinge to hood bolts to 10 N.m (89 lb in).
  8. Close the hood.
scientia non olet · About LEMON Manuals