LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 512 (Power Steering System) >> Repair Instructions >> Power Steering Fluid Reservoir Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
  2. Remove the right side engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side .
  3. Remove as much power steering fluid from the remote power steering fluid reservoir as possible.
  4. Place drain pans under the vehicle as needed.
    5. Fig 1: Power Steering Reservoir Inlet Hose And Clamp
    GM1856010Courtesy of GENERAL MOTORS COMPANY
  5. Disconnect the power steering reservoir inlet hose (1).
    6. Fig 2: View Of Power Steering Fluid Reservoir Outlet Hose & Clamp
    GM1856009Courtesy of GENERAL MOTORS COMPANY
  6. Disconnect the power steering fluid reservoir outlet hose (1).
    7. Fig 3: Power Steering Fluid Reservoir Bracket And Bolts
    GM2075295Courtesy of GENERAL MOTORS COMPANY
  7. Remove the remote power steering fluid reservoir bracket bolts (1).
  8. Remove the remote power steering fluid reservoir bracket (2).
  9. Transfer any parts as needed.
scientia non olet · About LEMON Manuals