Installation Procedure
WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- Install NEW sealing washers (3) to the air conditioning compressor hose and the air conditioning refrigerant heat exchange (4). Refer to Air Conditioning System Seal Replacement .
- Install the air conditioning refrigerant heat exchange to the condenser (4).
- Install the air conditioning compressor hose (2) to the condenser.
- Install the air conditioning compressor hose nut (1) at the condenser and tighten to 22 N.m (16 lb ft).
- Install the front bumper fascia. Refer to Front Bumper Fascia Replacement (Acadia)Front Bumper Fascia Replacement (Enclave)Front Bumper Fascia Replacement (Traverse) .
- Lower the vehicle.
- Install NEW sealing washers (3) to the air conditioning compressor hose. Refer to Air Conditioning System Seal Replacement .
- Install the air conditioning compressor hose (2) to the compressor.
- Install the air conditioning compressor hose nut (1) at compressor and tighten to 22 N.m (16 lb ft).
- Install NEW sealing washers (3) to the air conditioning compressor hose. Refer to Air Conditioning System Seal Replacement .
- Install the air conditioning compressor hose (2) to the air conditioning refrigerant heat exchange.
- Install the air conditioning compressor hose nut (1) to air conditioning refrigerant heat exchange and tighten to 22 N.m (16 lb ft).
- Install the coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement .
- Evacuate and charge the A/C system. Refer to Refrigerant Recovery and Recharging .
- Install the front compartment front sight shield. Refer to Front Compartment Front Sight Shield Replacement (Enclave)Front Compartment Front Sight Shield Replacement (Traverse)Front Compartment Front Sight Shield Replacement (Acadia) .
CAUTION:
Refer to Fastener Caution .