LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 420 (Hydraulic Brake System) >> Repair Instructions >> Brake Pedal Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left side instrument panel (I/P) insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  2. Remove the driver knee bolster. Refer to Driver Knee Bolster Replacement (Acadia)Driver Knee Bolster Replacement (Enclave)Driver Knee Bolster Replacement (Traverse) .
  3. Remove the accelerator pedal position sensor. Refer to Accelerator Pedal Position Sensor Replacement .
    4. Fig 1: Brake Pedal Bracket Bolts
    GM1862122Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the brake pedal position sensor electrical connector (1).
  5. Remove the 2 brake pedal bracket bolts (2).
    6. Fig 2: Brake Pedal Pushrod Retainer
    GM1862124Courtesy of GENERAL MOTORS COMPANY
  6. Remove the brake pedal pushrod retainer (1).
    7. Fig 3: Brake Pedal Pushrod Clevis Pin
    GM1862126Courtesy of GENERAL MOTORS COMPANY
  7. Remove the brake pedal pushrod clevis pin.
  8. Remove the intermediate steering shaft. Refer to Intermediate Steering Shaft Replacement .
    9. Fig 4: Locating Vacuum Booster Nuts
    GM1862128Courtesy of GENERAL MOTORS COMPANY
  9. Remove the 4 vacuum booster nuts.
  10. Position the vacuum brake booster and master cylinder assembly forward slightly to allow the brake pedal and bracket assembly to clear the booster studs.
  11. Remove the brake pedal assembly.
scientia non olet · About LEMON Manuals