LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions - On Vehicle >> Shift Control Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Position the manual transmission control assembly into the vehicle.
    2. Fig 1: Identifying Shift Control Rod Pins
    GM1979753Courtesy of GENERAL MOTORS CORP.
  2. Install the center shift control rod pin (2).
  3. Install the left and right side shift control rod pins (1,3).
    4. Fig 2: Identifying Shift Control Rod Pins & Retainers
    GM1979754Courtesy of GENERAL MOTORS CORP.
  4. Install the center shift control rod pin retainer (2).
  5. Rotate the left and right side shift control rod pins (1,2) in order to lock the retainers into place on the transmission.
  6. Install the shift control mounting nuts.
  7. Raise the transmission.
  8. Install the transmission support. Refer to Transmission Mount Replacement
  9. Remove the jack supporting the transmission.
  10. Install the propeller shaft. Refer to Two-Piece Propeller Shaft Replacement
  11. Install the exhaust system. Refer to Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement (H-Pipe) or Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement (Vehicle Service)
  12. Lower the vehicle.
  13. Install the front floor console front cover. Refer to Front Floor Console Front Cover Replacement (Without UMQ) or Front Floor Console Front Cover Replacement (With UMQ)
  14. Install the transmission control lever knob. Refer to Transmission Control Lever Knob Replacement
scientia non olet · About LEMON Manuals