LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Engine Exhaust System >> Repair Instructions >> Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement (Vehicle Service)

Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement (Vehicle Service)

Fig 1: Exhaust Muffler with Resonator, Exhaust & Tail Pipe (Vehicle Service)
GM2290109Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the underbody brace.Refer to Underbody Brace Replacement 
1 Exhaust Clamp Bolt (Qty: 4)
CAUTION: Refer to Fastener Caution .

Tighten:  48 N.m (35 lb ft)
2 Exhaust Hanger Rods
3 Muffler Assembly.
Tip:  This exhaust system is not serviced as an assembly, but this procedure is for reference only.

Procedure

  1. Remove the exhaust clamps from each catalytic converter
  2. With the aid of an assistant, remove the exhaust hanger rods from the exhaust isolators.

    3. Tip:  Squeeze the rear muffler hanger rods through the isolators using a suitable tool.

  3. Lubricate the exhaust hanger rods for ease of installation.
scientia non olet · About LEMON Manuals