LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions - On Vehicle >> Reverse Lockout Solenoid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Reverse Lockout Assembly
    GM1434394Courtesy of GENERAL MOTORS CORP.
  1. If removed, inspect the reverse lockout assembly O-ring. Replace the reverse lockout assembly O-ring if necessary.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the reverse lockout assembly and bolt and tighten to 18 N.m (13 lb ft).
  3. Install the reverse lockout solenoid using the J 41099  . See Special Tools . Inspect and replace the O-ring if necessary.

    Tighten the reverse lockout solenoid to 40 N.m (30 lb ft).

  4. Connect the reverse lockout solenoid electrical connector.
  5. Install the transmission mount. Refer to Transmission Rear Mount Replacement 
  6. Remove the transmission jack.
  7. Install the exhaust system. Refer to Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement (H-Pipe) or Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement (Vehicle Service)
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals