LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions - On Vehicle >> Gear Select/Skip Shift Solenoid Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle
  2. Remove the exhaust system. Refer to Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement (H-Pipe) or Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement (Vehicle Service)
  3. Remove the propeller shaft. Refer to Two-Piece Propeller Shaft Replacement
  4. Support the transmission with a suitable jack.
  5. Remove the transmission support retaining fasteners from the vehicle body.
  6. Slightly lower the transmission to gain access to the solenoid.
  7. Disconnect the solenoid electrical connector.
    8. Fig 1: TFT Sensor, Reverse Lockout Solenoid & Transmission Fluid Fill PLug
    GM2197320Courtesy of GENERAL MOTORS CORP.
  8. Remove the solenoid (1) from the transmission.
scientia non olet · About LEMON Manuals