LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - AISIN AY6) >> Repair Instructions - On Vehicle >> Transmission Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    NOTE: Ensure clearance is maintained between the transmission and the following:
    • The clutch assembly
    • The input shaft
    • The catalytic converters
    • The wiring harnesses
    • The propeller shaft
  1. Using the transmission jack, carefully raise the transmission to the vehicle.
    2. Fig 1: Identifying Transmission Bolts
    GM1979746Courtesy of GENERAL MOTORS CORP.
  2. Align the transmission with the engine dowels.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the transmission bolts (1-6) and tighten to 50 N.m (37 lb ft).
    4. Fig 2: Identifying Clutch Retaining Hose Retaining Clip & Clutch Hydraulic Hose
    GM802767Courtesy of GENERAL MOTORS CORP.
  4. Install the clutch hydraulic hose retaining clip (1) to the clutch slave cylinder.
    5. NOTE: Ensure the clutch hydraulic hose is routed in an upward direction above the clutch slave cylinder with no sharp bends, kinks, or downward loops. Ensure the clutch hydraulic hose does not come in contact with any sharp or potentially hot surfaces.
  5. Install the clutch hydraulic hose to the vehicle.
  6. Align the clutch hydraulic hose locating tab with the notch in the slave cylinder hose fitting.
  7. Push the clutch hydraulic hose (2) into the clutch slave cylinder until a "click" is heard.
  8. Tug gently on the clutch hydraulic hose (2) to ensure proper retention to the clutch slave cylinder.
  9. Install the shift control rods to the transmission. Refer to Shift Control Assembly Replacement .
  10. Remove the transmission jack.
  11. Install the transmission support. Refer to Transmission Mount Replacement .
    12. Fig 3: Identifying Electrical Harness & Retainers
    GM1979752Courtesy of GENERAL MOTORS CORP.
  12. Install the electrical harness retainers (2) to the transmission.
    13. Fig 4: Identifying Electrical Connectors & Harness Retainers
    GM1979751Courtesy of GENERAL MOTORS CORP.
  13. Install the electrical harness retainers (1) to the transmission.
  14. Connect the electrical connector (4) to the backup lamp switch.
  15. Connect the electrical connector to the vehicle speed sensor.
  16. Install the propeller shaft. Refer to Two-Piece Propeller Shaft Replacement .
  17. Install the exhaust system. Refer to Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement (H-Pipe) or Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement (Vehicle Service) .
  18. Inspect the transmission fluid level.
  19. Lower the vehicle.
  20. Install the heater inlet and outlet pipes in the vehicle. Refer to Heater Inlet And Outlet Pipe Replacement (LLT)
  21. Install the transmission control lever knob. Refer to Transmission Control Lever Knob Replacement .
  22. Bleed the clutch hydraulic system. Refer to Hydraulic Clutch System Bleeding .
scientia non olet · About LEMON Manuals