Headlamp Replacement (Enclave)

Fig 1: View Of Headlamp (Enclave)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement (Acadia) or Front Bumper Fascia Replacement (Enclave) or Front Bumper Fascia Replacement (OUTLOOK) or Front Bumper Fascia Replacement (Traverse) .
1	Headlamp Bolt (Qty: 4) CAUTION: Refer to Fastener Caution . Tighten: 6 N.m (53 lb in)
2	Fender Brace Bolt to Headlamp Tighten: 2 N.m (18 lb in)
3	Headlamp Horizontal and Vertical Adjustment Nuts (Qty: 2) Procedure Set the cam adjusting nuts to the nominal setting of 6 turns off fully seated prior to installing the new assembly. Check the front bumper fascia to headlamp finish fit and adjust the cam nuts accordingly to achieve an even fit.
4	Headlamp Vertical Adjusting Bolt Bushing
5	Headlamp Assembly Procedure Gently pull forward the headlamp assembly. Disconnect the forward lamp harness from the headlamp assembly electrical connector. Remove the headlamp from vehicle.