Front Bumper Fascia Replacement (Traverse)

Fig 1: View Of Front Bumper Fascia (Traverse)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the front compartment sight shield. Refer to Front Compartment Sight Shields Replacement (Acadia) or Front Compartment Sight Shields Replacement (Enclave) or Front Compartment Sight Shields Replacement (OUTLOOK) or Front Compartment Sight Shields Replacement (Traverse) . Remove the front wheelhouse front liner. Refer to Front Wheelhouse Front Liner Replacement (Traverse) or Front Wheelhouse Front Liner Replacement (Outlook) .
1	Front Bumper Fascia Push-Pin (Qty: 4)
2	Front Bumper Fascia Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten: 10 N.m (89 lb in)
3	Front Bumper Fascia Fender Tab Tip: Carefully push a small nylon wedge between the fascia and the fender. Insert a small flat-bladed tool into the fascia slot and depress the tabs one at a time and pull on the fascia at the same time to gradually remove the fascia from the fender.
4	Front Bumper Fascia Headlamp Bracket Tip: Carefully push a small nylon wedge between the fascia and the fender. Insert a small flat-bladed tool into the fascia slot and depress the tabs one at a time and pull on the fascia at the same time to gradually remove the fascia from the headlamp bracket.
5	Front Bumper Fascia Procedure Disconnect any electrical connectors. Transfer parts as needed.