Instrument Panel (I/P) Retainer Replacement

Fig 1: Instrument Panel (I/P) Retainer Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedures Remove the instrument panel center support bracket. Refer to Bracket Replacement - Instrument Panel (I/P) Center Support . Lower the steering column and position out of the way. Refer to Steering Column Replacement . Remove the instrument panel cluster assembly. Refer to Instrument Panel Cluster (IPC) Replacement . Remove the instrument panel upper trim pad assembly. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper . Remove the HVAC control assembly. Refer to HVAC Control Assembly Replacement . Remove the radio. Refer to Radio Replacement . Remove the left and right windshield garnish moldings. Refer to Windshield Garnish Molding Replacement . Remove the left and right instrument panel end covers. Refer to Instrument Panel (I/P) Outer Trim Cover Replacement . Remove the instrument panel compartment assembly. Refer to Compartment Replacement - Instrument Panel (I/P) .
1	Screw, Instrument Panel Retainer (Qty: 11) Tighten: 2 N.m (18 lb in)
2	Push Pin Fasteners, Instrument Panel Retainer (Qty: 4)
3	Bolt, Instrument Panel Retainer (Qty: 10) Tighten: 2 N.m (18 lb in)
4	Retainer Assembly, Instrument Panel Tip: Note routing of the wiring harness to aid in the reinstallation. Disconnect electrical connectors. With the aid of an assistant, remove the retainer from the vehicle.