Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
- With the ignition OFF, inspect the crankshaft balancer bolt for the proper torque. Refer to FASTENER TIGHTENING SPECIFICATIONS
.
- If the crankshaft balancer bolt is not at the proper torque, refer to CRANKSHAFT BALANCER REPLACEMENT .
- Inspect for incorrect installation of the CMP sensor. Refer to CAMSHAFT POSITION SENSOR HOUSING REMOVAL .
- Inspect the engine for correct valve timing. Refer to TIMING CHAIN, SPROCKETS, AND/OR TENSIONER REPLACEMENT .