LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Mass Air Flow (MAF) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the left front tire and wheel. Refer to Tire and Wheel Removal and Installation (5 Lug Wheel) or Tire and Wheel Removal and Installation (4 Lug wheel) in Tires and Wheels.
  3. Remove the left front fender liner. Refer to Front Fender Liner Replacement in Body Front End.
  4. Remove the left front splash shield-engine. Refer to Splash Shield Replacement - Engine in Body Front End.
    5. Fig 1: View Of MAF Sensor
    GM1386444Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the electrical connector from the mass air flow (MAF) sensor.
  6. Remove the 2 fasteners.
  7. Remove the MAF sensor from the air cleaner housing.
scientia non olet · About LEMON Manuals