LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Mass Air Flow (MAF) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of MAF Sensor
    GM1386444Courtesy of GENERAL MOTORS CORP.
  1. Install the MAF sensor into the air cleaner housing.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Secure the MAF sensor to the air cleaner housing with the 2 fasteners.

    Tighten:  Tighten the 2 fasteners to 2 N.m (18 lb in).

  3. Connect the MAF sensor electrical connector.
  4. Install the left front splash shield-engine. Refer to Splash Shield Replacement - Engine in Body Front End.
  5. Install the left front fender liner. Refer to Front Fender Liner Replacement in Body Front End.
  6. Install the left front tire and wheel. Refer to Tire and Wheel Removal and Installation (5 Lug Wheel) or Tire and Wheel Removal and Installation (4 Lug wheel) in Tires and Wheels.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals