LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 788 (Interior Trim) >> C-Pillar Trim Removal/Installation >> 4 Door

4 Door

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat. (See REAR SEAT REMOVAL/INSTALLATION .)
  2. Remove the rear scuff plate. (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
  3. Remove the tire house trim. (See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
  4. Partially peel back the seaming welt.
  5. Detach clips A and locator pin B, using a fastener remover.
  6. Detach tabs C, D and E from the body and remove the C-pillar trim.
  7. Install in the reverse order of removal.
    Fig 1: Removing/Installing C-Pillar Trim - 4 Door
    G02566831Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals