LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 779 (Glass/Windows/Mirrors) >> Rear Window Glass Removal >> 4 Door

4 Door

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the following parts:
    1. Rear seat (See REAR SEAT REMOVAL/INSTALLATION .)
    2. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    3. Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
    4. C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION .)
    5. Rear package trim (See REAR PACKAGE TRIM REMOVAL/INSTALLATION .)
  3. Disconnect the filament connector.
  4. Set the headliner out of the way.
  5. Apply protective tape along the edge of the body.
  6. Cut the rear window glass molding lip using a razor.
    WARNING:
    • Using a razor with bare hands can cause injury. Always wear gloves when using a razor.
    NOTE:
    • The rear window glass molding is a replacement part.
      Fig 1: Locating Rear Window Glass Molding Sealant Cutting Area (4 Door)
      G02566738Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals