LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Wheel Cylinder >> Installation

Wheel Cylinder: Installation

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the rear brake cylinder to the vehicle. Install the rear brake cylinder retaining bolts. Tighten the rear brake cylinder retaining bolts to specification. See TORQUE SPECIFICATIONS  .
  2. Connect the brake pipe to the rear brake cylinder. Tighten the rear brake pipe to the rear brake cylinder to specification. See TORQUE SPECIFICATIONS  .
  3. Install the rear brake shoes. See REAR BRAKE SHOES  . Install the rear brake drums. See BRAKE DRUM  .
  4. Remove the pin to the park brake lever. See ENABLING THE PARK BRAKE CABLE AUTOMATIC ADJUSTER  .
  5. Install the tire and the wheel on the vehicle. Tighten to specifications. See TORQUE SPECIFICATIONS  .
  6. Bleed the brake system. See BLEEDING, FILLING & FLUSHING BRAKE SYSTEM  . Adjust the rear brakes. See DRUM BRAKE ADJUSTMENT  . Adjust the park brake if necessary. See PARKING BRAKE ADJUSTMENT  .
scientia non olet · About LEMON Manuals