Parking Brake Adjustment

The pedal must be free from corrosion and lubricated for correct operation. The pedal must be returned to the released position without sticking or binding. If a problem is present, check the cable routing for binding or misadjusted cables.

The cable tension is self adjusting. However, during normal brake lining wear, it is possible that the cable tension may need adjustment due to the increased pedal travel. If the park brake requires adjustment, check for the following conditions:

• Inspect the rear brake shoe for wear. The rear brake shoe thickness should not be more than 80 percent worn (approximately).
• Make sure the system is free from corrosion and free from sticking or binding.

1. Block the front wheels.
2. Raise and support the rear axle with safety stands.
3. Place the park brake pedal to the FULL up position.
4. Measure the threads on the equalizer. Adjust the threads to the following specifications:
   • Passenger/Cargo to 0.511" (13 mm).
   • Cutaway/Upfitters to 0.826" (21 mm).
5. Verify that the vehicle will hold position with the park brake pedal depressed.
6. If additional adjustments need to be made, rotate the adjuster nut using 5 mm (0.196 in) increments until the rear wheels obtain a moderate drag.
7. Back off the adjuster nut until the rear wheels are free from drag.
8. Verify that the vehicle will hold position with the park brake pedal depressed.
9. Remove the safety stands. Lower the vehicle.
10. Unblock the front wheels.