LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 471 (Automatic Transmission - Overhaul - ALLISON) >> Component Disassembly & Reassembly >> Main Shaft Inspection

Main Shaft Inspection

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, 2003 Chevrolet Cab & Chassis Silverado, and 2002 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect main shaft pilots for damage. Measure main shaft pilots (dimension "A"). See Fig 1. Compare measurements to specifications. See PLANETARY GEAR MODULE SPECIFICATIONS  table under TRANSMISSION SPECIFICATIONS. Replace main shaft if not within specification.
  2. Inspect main shaft journal contact area for damage. Measure journal contact area for P2 planetary bushing (dimension "B"). Compare measurements to specifications. See PLANETARY GEAR MODULE SPECIFICATIONS  table under TRANSMISSION SPECIFICATIONS. Replace main shaft if not within specification.
Fig 1: Main Shaft Inspection Points
G00117157Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals