LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 453 (Supplemental Inflatable Restraint System) >> Removal & Installation >> Front End Discriminating Sensor (Side Impact Air Bag) >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See ZONE 1  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Remove Connector Position Assurance (CPA) clip from applicable front end discriminating sensor connector. See Figure & Figure . Disconnect front end discriminating sensor connector. Remove EFS sensor mounting bolts. Remove electronic frontal sensor.
  3. To install, reverse removal procedure. Tighten front end discriminating sensor bolts to specification. See TORQUE SPECIFICATIONS . Activate air bag system. See ZONE 1  under DISABLING & ACTIVATING AIR BAG SYSTEM.
scientia non olet · About LEMON Manuals