LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1982 (Hybrid Engine Electrical System 2.4L (Hp7)) >> Repair Instructions >> Battery Positive Cable Replacement (HP7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (HP7) .
    2. Fig 1: ECM Bracket Bolts And Nuts
    GM2030262Courtesy of GENERAL MOTORS CORP.
  2. Remove the electronic control module bracket retaining nuts (1) and bolts (2).
  3. Disconnect the positive battery junction block assembly from the bracket.
    4. Fig 2: Positive Battery Cable Terminal Nut
    GM1999419Courtesy of GENERAL MOTORS CORP.
  4. Loosen the positive battery cable terminal nut (1) and secure the battery positive cable (2) out of the way.
  5. Remove the generator control module cover. Refer to Generator Control Module Cover Replacement
    6. Fig 3: Fusible Link Nut And Bolt
    GM1998501Courtesy of GENERAL MOTORS CORP.
  6. Remove the following components from the generator control module.
    • Fusible link nut (1)
    • Fusible link bolt (2)
  7. Remove the fusible link cable from the generator control module.
  8. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    9. Fig 4: Starter Motor Electrical Connector
    GM1878823Courtesy of GENERAL MOTORS CORP.
  9. Disconnect the positive cable (1) from the starter.
  10. Remove the positive battery cable from the vehicle.
scientia non olet · About LEMON Manuals