LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1961 (Hybrid Controls - 3.6L (Hp5) - Introduction) >> Repair Instructions >> Generator Control Module 3-Phase Cable Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transaxle from the vehicle. Refer to Transmission Replacement .
  2. Remove the torque dampener. Refer to Torque Dampener Removal .
  3. Remove the torque dampener and differential housing assembly. refer to Torque Dampener and Differential Housing with Fluid Pump Removal .
  4. Remove the 3 phase cable to stator bolts.
  5. Remove the cable to case retaining bolts.
  6. Remove the drive motor/generator power inverter module cable 3 phase assembly "A".
  7. Remove the case cover. Refer to Case Cover Removal .
  8. Remove the 3 phase cable to stator bolts.
  9. Remove the cable to case retaining bolts.
  10. Remove the drive motor/generator power inverter module cable 3 phase assembly "B".
scientia non olet · About LEMON Manuals