LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1745 (Automatic Transaxle - AF33-5 (Removal & Installation, Service & Overhaul)) >> Repair Instructions >> Oil Cooler Pipe Seals Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Insert a new transaxle cooler line seal into the case bore.
    2. Fig 1: Removing Nub From J 41239-1
    GM992891Courtesy of GENERAL MOTORS CORP.
  2. Remove the nub from the J 41239-1  . See Special Tools .
    3. Fig 2: Installing Nub Of J 41239-1 On Transaxle Cooler Line Seal
    GM948673Courtesy of GENERAL MOTORS CORP.
  3. Install the nub of the J 41239-1  on the transaxle cooler line seal. See Special Tools .
  4. Tap the new transaxle cooler line seal into the case bore.
    5. Fig 3: View Of Transaxle Oil Cooler Lines
    GM945444Courtesy of GENERAL MOTORS CORP.
  5. Install the transaxle oil cooler line assembly to the transaxle.
    6. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  6. Install the transaxle oil cooler line assembly nut.

    Tighten:  Tighten the transaxle cooler line retaining nut to 7 N.m (62 lb in).

  7. Lower the vehicle.
    8. NOTE: Saturn automatic transaxle fluid (ATF), P/N 21005966 and P/N 21019223, is not compatible with this transaxle. If Saturn ATF is used, transaxle damage will result. This transaxle uses Saturn T-IV fluid P/N 22689186.
  8. Add fluid to the transaxle. Refer to Transmission Fluid Replacement  procedure located in this service manual.
  9. Start the engine and check for leaks.
scientia non olet · About LEMON Manuals