LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1465 (Drive Axle - Limited-Slip Differential) >> Diagnostic Information and Procedures >> Locking Rear Axle Locks in Turns

Locking Rear Axle Locks in Turns

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Locking Rear Axle Locks in Turns

Condition Action
The governor assembly is tight in the case. Free up the governor assembly. Refer to Locking Differential Disassemble  and Locking Differential Assemble  .
A governor flyweight spring is broken or weak. Replace the governor assembly and the latching bracket. Refer to Locking Differential Disassemble  and Locking Differential Assemble  .
The flyweight in the governor assembly is stuck open. Replace the governor assembly and the latching bracket. Refer to Locking Differential Disassemble  and Locking Differential Assemble  .
The cam plate or the governor drive teeth are broken. Replace the cam plate, the governor assembly, and the latching bracket. Refer to the following:
  1. Locking Differential Disassemble 
  2. Locking Differential Cam Unit Disassemble 
  3. Locking Differential Cam Unit Assemble 
  4. Locking Differential Assemble