LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Diagnostic Information and Procedures >> DTC B3967 >> Test Description

Test Description

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

  1. 2:  Tests the lower left endgate latch actuator and upper right endgate latch actuator circuits for a short to ground or an open.
DTC B3967

Step Action Yes No
Schematic Reference: Body Rear End Schematics 
Connector End View Reference: Body Rear End Connector End Views 
1 Did you perform the Body Rear End Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Body Rear End 
Test the lower left endgate latch actuator and upper right endgate latch actuator circuits for a short to ground or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 5  Go to Step 3 
3 Inspect for poor connections at the harness connector of the endgate module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 5  Go to Step 4 
4
  1. Perform the endgate window learn procedure. Refer to Window Learn Cycle - Endgate 
  2. Replace the endgate module. Refer to Module Rear Body Control Replacement - Endgate  .
Did you complete the replacement?
Go to Step 5  -
5
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?
Go to Step 2  System OK