LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 363 (Starting System) >> Diagnostic Information & Procedures >> Starter Solenoid Clicks, Engine Does Not Crank

Starter Solenoid Clicks, Engine Does Not Crank

WARNING: This page is about a different car, the 2003 Pontiac Montana and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Did you perform the Engine Electrical Diagnostic System Check? If yes, go to next step. If no, see DIAGNOSTIC SYSTEM CHECK - ENGINE ELECTRICAL .
  2. Turn the ignition to the START position. Did the starter solenoid click? If yes, go to next step. If no, see STARTER SOLENOID DOES NOT CLICK .
  3. Inspect the engine and belt drive system for mechanical binding (seized engine, seized generator). Does the engine move freely? If yes, go to next step. If no, see 3.4L V6 article in ENGINE MECHANICAL in ENGINE.
  4. Test the battery positive cable between the battery and the starter solenoid for high resistance. Did you find and correct the condition? If yes, go to step  8. If no, go to next step.
  5. Test the ground circuit between the battery and the starter motor for a high resistance. Did you find and correct the condition? If yes, go to step  8. If no, go to next step.
  6. Inspect for poor connections at the starter. See TESTING FOR INTERMITTENT & POOR CONNECTIONS . Did you find and correct the condition? If yes, go to step  8. If no, go to next step.
  7. Replace the Starter. See STARTER  under REMOVAL & INSTALLATION. Go to next step.
  8. Operate the system for which the symptom occurred. Did you correct the condition? If no, go back to step  2.