Removal Procedure
WARNING:
The battery must be disconnected to prevent the brake master cylinder from pressurizing the hydraulic system during its automated self diagnostic tests that can possibly occur when a door is opened or the key transmitter is activated. Failure to follow this precaution may cause personal injury.
WARNING:
- Place the ignition switch in the OFF position.
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Without draining the engine coolant and without disconnecting the hoses, remove and position aside the radiator surge tank. Radiator Surge Tank Replacement (LGX)Radiator Surge Tank Replacement (LSY)
Brake Pipe Fitting (1) - Disconnect
- Plug the brake pressure modulator valve (BPMV) outlet port and the brake pipe end to prevent brake fluid loss and contamination.
- Brake Pipe Clip (2) - Release
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove the tire and wheel assembly. Tire and Wheel Removal and Installation
Brake Pipe Fitting (1) - Disconnect
- Brake Pipe (2) - Remove