LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 V, RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Brake Pedal Removal and Installation >> Installation Procedure

Installation Procedure

  1. GM5880984Courtesy of GENERAL MOTORS COMPANY

    Install a NEW brake pedal retainer (1) to the brake pedal.

  2. Ensure the locking tabs on the brake pedal retainer are fully engaged in the brake pedal.
  3. GM5486242Courtesy of GENERAL MOTORS COMPANY

    Using an assistant to reposition the brake master cylinder - with power brake booster and electronic brake control module, install the brake pedal assembly (3).

  4. CAUTION:

    Refer to Fastener Caution .

  5. Brake Master Cylinder Nut (2) - Install and tighten [2x] - Fastener Specifications 
  6. Brake Pedal Nut (1) - Install and tighten [2x] - Fastener Specifications 
  7. GM5880985Courtesy of GENERAL MOTORS COMPANY

    Engage the brake pedal (1) to the brake master cylinder push rod by pushing inwards.

  8. Ensure the brake pedal retainer is secured by lightly pulling rearward on the brake pedal (1).
  9. GM5333075Courtesy of GENERAL MOTORS COMPANY

    Brake Pedal Position Sensor Electrical Connector (2) - Connect

  10. Retainer (1) - Secure [2x]
  11. GM5644434Courtesy of GENERAL MOTORS COMPANY

    Air Distributor Duct Bolt (1) - Install and tighten - Fastener Specifications

  12. GM5454443Courtesy of GENERAL MOTORS COMPANY

    Serial Data Gateway Bracket (2) - Install

  13. Serial Data Gateway Module Bracket Bolt (1) - Tighten [2x] - Fastener Specifications
  14. Connect and position the wiring harness.
  15. GM5454224Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Typical wiring harness shown. Individual wiring harnesses may differ based on option content.

    Connect the electrical connectors (1)

  16. Floor Front Air Outlet Duct Bolt (1) - Install and tighten - Fastener Specifications
  17. GM5454049Courtesy of GENERAL MOTORS COMPANY

    Instrument Panel Knee Bolster Deflector (2) - Install

  18. Instrument Panel Tie Bar Brace Bolt (1) - Install and tighten [3x] - Fastener Specifications
  19. GM5325852Courtesy of GENERAL MOTORS COMPANY

    Floor Front Air Outlet Duct - Left Side Outer (2) - Install

  20. GM5446428Courtesy of GENERAL MOTORS COMPANY

    Connect and position the wiring harness.

  21. Instrument Panel Knee Bolster (1) - Install
  22. GM5446424Courtesy of GENERAL MOTORS COMPANY

    Data Link Connector Bolt (1) - Install and tighten [2x] - Fastener Specifications

  23. Instrument Panel Knee Bolster Bolt (2) - Install and tighten [3x] - Fastener Specifications
  24. Connect the electrical connector.
  25. GM5433957Courtesy of GENERAL MOTORS COMPANY

    Connect the electrical connector.

  26. Instrument Panel Center Trim Pad (1) - Install
  27. Return the steering column to its original position.
  28. GM5310879Courtesy of GENERAL MOTORS COMPANY

    Connect the electrical connector.

  29. Instrument Panel Lower Trim Panel Insulator (1) - Install
  30. GM5310878Courtesy of GENERAL MOTORS COMPANY

    Install the tabs into the instrument panel lower trim panel insulator (1).

  31. GM5310877Courtesy of GENERAL MOTORS COMPANY

    Instrument Panel Lower Trim Panel Insulator Retainer (1) - Install

  32. Instrument Panel Insulator Bolt (2) - Install and tighten [2x] - Fastener Specifications
  33. Instrument Panel Insulator Nut (3) - Install and tighten [2x] - Fastener Specifications
  34. GM5300282Courtesy of GENERAL MOTORS COMPANY

    Attach the hood primary latch release cable end retainer to the hood primary latch release cable handle (1).

  35. GM5421735Courtesy of GENERAL MOTORS COMPANY

    Instrument Panel Outer Trim Cover - Left Side (1) - Install

  36. GM5443235Courtesy of GENERAL MOTORS COMPANY

    Connect the electrical connector.

  37. Instrument Panel Lower Airbag - Driver Side (2) - Install
  38. Instrument Panel Lower Airbag Nut (1) - Install and tighten [2x] - Fastener Specifications
  39. Enable the SIR System. SIR Disabling and Enabling .
  40. Calibrate the brake pedal position sensor. Brake Pedal Position Sensor Calibration