Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- Prepare the 2 front brake caliper bolts for installation as follows:
- Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
- Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
- Apply thread locking adhesive to the external threads of the components. Adhesives, Fluids, Lubricants, and Sealers
- Ensure there are no gaps in the thread locking adhesive once applied to the component.
Front Brake Caliper (1) - Install
- Front Brake Caliper Bolt (2) - Install and tighten [2x] - Fastener Specifications
- Remove the plug from the brake hose outlet.
- Remove the plug the front brake caliper inlet.
Front Brake Hose (1) - Install
- Front Brake Hose Washer (3) - Install NEW [2x]
- Front Brake Hose Fitting (2) - Install and tighten - Fastener Specifications
{If equipped} Front Disc Brake Pad Wear Sensor (2) @ Front Brake Caliper - Install
- Front Brake Caliper Bleeder Valve Cap (1) - Install
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Bleed the brake system. Hydraulic Brake System Bleeding (JE5, J6G) , or Hydraulic Brake System Bleeding (J55)
- Check for brake system leaks.
- Install the front tire and wheel assembly. Tire and Wheel Removal and Installation
- Remove the support and lower the vehicle.
CAUTION: