Installation Procedure

Brake Pressure Modulator Valve Pipe - Install
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Do NOT tighten the brake pipe fitting until instructed.

Brake Pressure Modulator Valve Secondary Brake Pipe Fitting (1) - Install, but do NOT tighten
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Do NOT tighten the brake pipe fitting until instructed.

Brake Pressure Modulator Valve Primary Brake Pipe Fitting (1) - Install, but do NOT tighten
Courtesy of GENERAL MOTORS COMPANY

Retainer (1) - Secure
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Pipe Pass Through Grommet (1) - Secure
Install the powertrain. Engine Replacement
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Brake Pressure Modulator Valve Primary Brake Pipe Fitting (1) - Install and tighten 32 N.m (24 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Secondary Brake Pipe Fitting (1) - Install and tighten 32 N.m (24 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Secondary Brake Pipe Fitting (1) @ Brake Pressure Modulator Valve - Install and tighten 32 N.m (24 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Primary Brake Pipe Fitting (1) @ Brake Pressure Modulator Valve - Install and tighten 32 N.m (24 lb ft)
Engine Wiring Harness Fuse Block Bracket - Install - Engine Wiring Harness Fuse Block Bracket Replacement (LGX)Engine Wiring Harness Fuse Block Bracket Replacement (LTA-Driver Side)Engine Wiring Harness Fuse Block Bracket Replacement (LTA-Passenger Side)
Bleed the brake system. Hydraulic Brake System Bleeding (Manual with LGX) Hydraulic Brake System Bleeding (Pressure with LGX) Hydraulic Brake System Bleeding (Pressure with LTA)
Air Inlet Grille Panel - Install - Air Inlet Grille Panel Replacement