Removal Procedure

WARNING:

WARNING:

Raise and support the vehicle. Lifting and Jacking the Vehicle (ATS) , or Lifting and Jacking the Vehicle (ATS-V)
Tire and Wheel Removal and Installation (Non V-Series) , or Tire and Wheel Removal and Installation (V-Series) - Remove
Front Wheelhouse Splash Shield Replacement (All Wheel Drive) , or Front Wheelhouse Splash Shield Replacement (Rear Wheel Drive) - Remove
Courtesy of GENERAL MOTORS COMPANY

Brake Pipe Fitting (1) - Disconnect
Cap the brake pipe fitting to prevent brake fluid loss and contamination.
Courtesy of GENERAL MOTORS COMPANY

Brake Hose Retainer (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Wheel Speed Sensor Wiring Harness Clip (1) [2x] @ Brake Hose - Release
Courtesy of GENERAL MOTORS COMPANY

Bolt (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Brake Hose Fitting Bolt (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Do not reuse the brake hose fitting gaskets.

Brake Hose Fitting Gasket (1) [2x] @ Front Brake Hose (2) - Remove and DISCARD
Front Brake Hose - Remove