LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Automatic Transmission - 6L80 (MYC) Or 6L90 (MYD) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Fluid Filler Tube And Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban 3500 HD, and 2018 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Transmission Oil Level Indicator
    GM1284301Courtesy of GENERAL MOTORS COMPANY
  1. Unlock the transmission oil level indicator.
  2. Remove the transmission oil level indicator.
    3. NOTE:

    Tie the engine wiring harness, between the oil level indicator tube and engine, to the engine, so when installing the new oil level indicator tube the harness will not get caught on the oil level indicator tube.

  3. Raise the vehicle.
  4. Support the transmission with a suitable jack.
  5. Remove the transmission crossmember. Refer to Transmission Support Crossmember Replacement (2WD)Transmission Support Crossmember Replacement (4WD) .
  6. Remove the transmission oil level indicator tube bracket nut.
  7. Remove the exhaust heat shield from the transmission. Refer to Transmission Heat Shield Replacement .
  8. Lower rear of transmission to allow for clearance to remove transmission oil level indicator tube.
  9. Remove the transmission oil level indicator tube from the transmission.
  10. Raise rear of transmission to allow for clearance to remove transmission oil level indicator tube from vehicle.
    11. Fig 2: Oil Level Indicator Tube And Seal
    GM1869804Courtesy of GENERAL MOTORS COMPANY
  11. Remove the oil level indicator tube (1) and seal (2) assembly.
  12. Remove the seal (2) from the oil level indicator tube (1).
scientia non olet · About LEMON Manuals