Seat Cushion Trim Cover and Pad Replacement (without HP2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Seat Cushion Trim Cover, Pad & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the front seat. Refer to Front Seat Replacement - Bucket (without HP2) . Remove the front seat recliner lever, if equipped. Refer to Driver or Passenger Seat Recliner Handle Replacement (without HP2) . Remove the front seat lumbar actuator knob, if equipped. Refer to Driver or Passenger Seat Lumbar Support Actuator Knob Replacement (without HP2) . Remove the front seat adjuster outer finish cover. Refer to Front Seat Cushion Outer Trim Panel Replacement (Power Seat without HP2) or Front Seat Cushion Outer Trim Panel Replacement (Manual Seat without HP2) .
1	Front Seat Adjuster Inner Finish Cover Refer to Front Seat Cushion Inner Trim Panel Replacement (without HP2) .
2	Front Seat Riser Finish Cover Tip: Pull rearward to disengage the cover from the seat riser.
3	Front Seat Cushion Cover and Pad Procedure Disengage the j-channel retainers from the seat cushion frame. Remove the seat cushion cover and pad from the seat cushion frame as an assembly.
4	Front Seat Cushion Pad Procedure: If working on the passenger seat, re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Control Module References .