Front Seat Cushion Outer Trim Panel Replacement (Power Seat without HP2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Seat Adjuster Outer Finish Cover & Screw

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Front Seat Adjuster Outer Finish Cover Screw CAUTION: Refer to Fastener Caution . Tighten: 2 N.m (18 lb in)
2	Front Seat Adjuster Outer Finish Cover Procedure Squeeze the tabs in the rear of the cover together to disengage the outer trim cover from the rear trim cover. Pull outward to release the retainers from the seat assembly. Disconnect the electrical connectors. If replacing the finish cover, remove the switches and install on new finish cover.

Callout

Component Name

Front Seat Adjuster Outer Finish Cover Screw

CAUTION: Refer to Fastener Caution .

Tighten: 2 N.m (18 lb in)

Front Seat Adjuster Outer Finish Cover

Procedure

Squeeze the tabs in the rear of the cover together to disengage the outer trim cover from the rear trim cover.
Pull outward to release the retainers from the seat assembly.
Disconnect the electrical connectors.
If replacing the finish cover, remove the switches and install on new finish cover.