Rear Seat Riser Replacement (Tahoe/Yukon/Escalade with Bucket)

Fig 1: View Of Rear Seat Riser & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure:  Remove the rear seat. Refer to Rear Seat Replacement (Tahoe with HP2)  or Rear Seat Replacement (Avalanche/Escalade EXT)  or Rear Seat Replacement (Tahoe/Yukon/Escalade with Split Bench)  or Rear Seat Replacement (Tahoe/Yukon/Escalade with Bucket Seat) .
1	Rear Seat Riser Finish Cover Screw NOTE: Refer to Fastener Notice . Tighten:  2 N.m (18 lb in)
2	Rear Seat Riser Finish Cover
3	Rear Seat Riser Finish Cover
4	Rear Seat Riser Bolt (Qty: 2) Tighten:  9 N.m (80 lb in)
5	Rear Seat Riser Procedure:  Disconnect the seat riser strut from the seat riser.