Rear Seat Back Cushion Latch Cable Replacement (Tahoe/Yukon/Escalade with Bucket)

Fig 1: View Of Rear Seat Back Cushion Latch Cable & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the rear seat. Refer to Rear Seat Replacement (Tahoe with HP2) or Rear Seat Replacement (Avalanche/Escalade EXT) or Rear Seat Replacement (Tahoe/Yukon/Escalade with Split Bench) or Rear Seat Replacement (Tahoe/Yukon/Escalade with Bucket Seat) .
1	Rear Seat Cushion Trim Panel Refer to Rear Seat Cushion Trim Panel Replacement (Tahoe/Yukon/Escalade with Split Bench) or Rear Seat Cushion Trim Panel Replacement (Avalanche/Escalade EXT) or Rear Seat Cushion Trim Panel Replacement (Tahoe/Yukon/Escalade with Bucket) .
2	Rear Seat Recliner Handle Refer to Rear Seat Recliner Handle Replacement (Tahoe/Yukon/Escalade with Bucket) .
3	Rear Seat Recliner Outer Finish Cover Refer to Rear Seat Cushion Outer Trim Panel Replacement (with ARS) .
4	Rear Seat Recliner Inner Finish Cover Refer to Rear Seat Cushion Inner Panel Replacement (Tahoe/Yukon/Escalade with Bucket) or Rear Seat Cushion Inner Panel Replacement (Tahoe/Yukon/Escalade with Split Bench) .
5	Rear Seat Riser Finish Cover Screw NOTE: Refer to Fastener Notice . Tip: Tilt the seat assembly up and forward to gain access to remove the screw. Tighten: 2 N.m (18 lb in)
6	Rear Seat Riser Finish Cover
7	Rear Seat Latch Cable Procedure The rear seat latch cable is self-adjusting, the seat must be in the upright position and fully locked in place. Both the sync cable in-line adjusters must be open with the button pulled out. Ensure that both the inboard and the outboard release levers are in the fully locked position. Push both the inline sync cables adjuster buttons in.
8	Rear Seat Back Cushion Latch Cable Procedure The rear seat back cushion latch cable is self-adjusting, the seat must be in the upright position and fully locked in place. Both of the cable in-line adjusters must be open with the button pulled out. Ensure that both the inboard and the outboard release levers are in the fully locked position. Push both of the inline cables adjuster buttons in.