Rear Hatch/Gate Ajar Indicator Inoperative
Rear Hatch/Gate Ajar Indicator Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Instrument Cluster Schematics and Release Systems Schematics Connector End View Reference: Displays and Gages Connector End Views and Vehicle Access Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 | Open the rear compartment. Is the trunk ajar message displayed? |
Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
| 3 |
|
Go to Step 9 | Go to Step 4 |
| 4 |
|
Go to Step 5 | Go to Step 7 |
| 5 | Connect a fused jumper between the rear compartment lid ajar switch signal and ground circuits. Is the trunk ajar message displayed? |
Go to Step 6 | Go to Step 8 |
| 6 | Inspect for poor connections at the harness connector of the rear compartment lid pull down actuator. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 12 | Go to Step 10 |
| 7 | Inspect for an open or high resistance in the trunk ajar switch signal circuit. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 12 | Go to Step 11 |
| 8 | Repair open or high resistance in the ground circuit of the rear compartment lid pull down actuator. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 12 | - |
| 9 | Replace the instrument panel cluster (IPC) message center. Refer to Control Module References
for replacement, setup and programming. Did you complete the repair? |
Go to Step 12 | - |
| 10 | Replace the rear compartment lid pull down actuator. Refer to Rear Compartment Lid Pulldown Switch Replacement
. Did you complete the repair? |
Go to Step 12 | - |
| 11 | Replace the BCM. Refer to Control Module References
for replacement, setup and programming. Did you complete the replacement? |
Go to Step 12 | - |
| 12 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |