Door Lock Indicator Malfunction
Door Lock Indicator Malfunction
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Door Lock/Indicator Schematics
, Door Control Module Schematics
and Instrument Cluster Schematics Connector End View Reference: Vehicle Access Connector End Views and Displays and Gages Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 | Verify that the door lock indicator is malfunctioning. Does the door lock indicator operate normally? |
Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
| 3 |
|
Go to Step 4 | Go to Step 6 |
| 4 | Test the appropriate door lock indicator voltage circuit for an open, short to ground or short to battery voltage. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 10 | Go to Step 5 |
| 5 | Test the appropriate door lock indicator ground circuit for an open or high resistance. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 10 | Go to Step 7 |
| 6 | Inspect for poor connections at the harness connector of the appropriate door control module. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 10 | Go to Step 8 |
| 7 | Inspect for poor connections at the harness connector of the appropriate door lock indicator. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 10 | Go to Step 9 |
| 8 |
IMPORTANT:
After replacing the door control module, perform the setup procedure. Replace the appropriate door control module. Refer to Control Module References
for replacement, setup and programming.Did you complete the replacement? |
Go to Step 10 | - |
| 9 | Replace the appropriate door lock indicator. Refer to Door Lock Status Indicator Replacement . Did you complete the replacement? |
Go to Step 10 | - |
| 10 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |