Rear Door Lock Replacement
Fig 1: View Of Rear Side Door Lock Bolt, Rear Inside Door Handle Cable & Rear Side Door Lock Assembly
| Callout | Component Name |
| Preliminary Procedures 1. Remove the interior trim panel. Refer to Rear Side Door Trim Panel Replacement . 2. Remove the door outside handle housing. Refer to Rear Side Door Outside Handle Housing Replacement . |
|
| 1 | Rear Side Door Lock Bolt (Qty: 2) Notice: Refer to Fastener Notice in the Preface section. Procedure 1. Release the inside handle cable retainers before removing the door lock. 2. Disconnect the door lock electrical connector. Tighten 10 N.m (89 lb in) |
| 2 | Rear Inside Door Handle Cable |
| 3 | Rear Side Door Lock Assembly Procedure Transfer the lock rods. |